TOTAL PRO GF 10 impact-resistant glass-filled (10%) composite based on TPU GF 10 with heat resistance up to 110°C for printing large gears, strong housings, mechanically loaded parts, aerodynamic body kits for cars.
It has a high chemical resistance to acid and alkali solutions, fats, oils, xylene, diesel fuel. Limited to gasoline, kerosene, acetone, dichloromethane.
Thanks to its low shrinkage (up to 0.9%), good interlayer adhesion and high abrasion resistance, TOTAL GF 10 plastic will be an excellent alternative to polyamide-based composites.
Perfectly amenable to drilling, threading.
For best results, it is recommended to dry before printing for 2-3 hours at a temperature of 65-75°C.
ATTENTION! Plastic is abrasive, it is recommended to print using a steel nozzle.
We can print your 3D model with TOTAL PRO GF 10
Nozzle temperature 220-245°C
Printing table temperature 60-100°C
Blowing the model as needed 20-60%
Print speed up to 100 mm / s
Plastic feed (Flow) 95-100%
Nozzle diameter from 0.4 mm (min)
Min. layer height 0.1 mm
Heat resistance (min / max) -50 to +110°C
Rod diameter tolerance 0.03 mm
Quantity per coil ~215m
Shore hardness D 85
Elongation at break 15%
Tensile modulus of elasticity 3000 Mpa
Maximum tensile strength ~75 Mpa
VIC softening point 110°C
Density ~1.4 g / cm3
Charpy impact strength (+23 C) 140 kj / m2
Charpy impact strength (-30 C) 80 kj / m2
Notched Sharpie impact strength (+23 C) 35 kj / m2
Notched Sharpie impact strength (-30 C) 10 kj / m2
Shrinkage in the manufacture of products 0.3-0.9%